log 46

A few more engine stand off ties (hand tied fiber ties more reliable than zipties). Purchased another stepdrill, angle meter to check angles on each propeller, and more sanding brushes.Drilled and sized up (6) holes in spinner back plate perfectly and evenly spaced to fit on prop spacer bushings...worked perfect! Feels great to get this right. Soft installed back plate and propeller! Two layups fiberglass inside of spinner, 2" wide for countersinks at back plate. Finishing spinner. Obtained instructions from Whirlwind for prop torquing etc. Need to go to fire stations for old fireproof insulation front/aft of wing in fuselage. Searching for Halon fire extinguisher. ACS key switch schematic for electric ignition, ready to finish & check. Camera charger found so photos coming soon.